The store will not work correctly in the case when cookies are disabled.
We use cookies to make your experience better.To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more
Tec7 X-TACK is a superior instant grab adhesive. It is super strong and holds up to 18kg instantly without the need for other fixtures or supports. It is permanently flexible and remains stable up to 40mm in thickness. It is instantly waterproof, it can be used on wet and dry surfaces. X-TACK stands out because of its superior initial adhesion and ultra-fast curing properties. It is the choice par excellence for vertical and hanging fittings that you do not want to see move or slide.
Additional Information:
Basis: MS polymer
Capacity: 290 ml
Specific weight: 1.49 g > cm³
Viscosity: Hard paste
Shore hardness (DIN 53505) after 3 weeks at 23°C > 50%
Relative humidity: + > - 54 Shore A
Shrinkage (DIN 52451): Approx. 5%
Density (DIN EN 27390): Does not sag up to a 40 mm thick joint
Elongation at break: > 500%
Modulus at 100% elongation 23°C (DIN 53504 S2): 1.0 N > mm²
Tensile strength (DIN 53504 S2): 2.20 N > mm²
Skin formation: 3-5 minutes
Hardening time(24 hr.): 2.70 mm
Hardening time(48 hr.): 4 mm
Temperature resistance: -40°C to +90°C
Chemical resistance (Good): Water, salt water, aliphatic solvents, oils, greases, diluted organic acids and lyes
Chemical resistance (Moderate): Esters, ketones and aromatics
Chemical resistance (Poor): Concentrated acids and chlorinated solvents
Weather resistance: Perfect
Shelf life: 15 months in closed, original packaging
Characteristics:
Already super-strong before curing: 600kg > m²
Stable with adhesive thickness of up to 40 mm
Permanently elastic
Free of phthalates, solvents and isocyanates
Safe on mirrors, no markings on natural stone
Almost odourless
Even on wet, slippery surfaces
Fungus and bacteria resistant
Water and airtight
Can be used on most building materials
Use:
Apply to clean, dust and grease-free substrate
If necessary clean with Tec7 cleaner or Multiclean
Apply with manual or air caulking gun (best with telescopic plunger)
Due to the wide variety of different plastic materials and compositions, as well as materials that are prone to stress cracking, preliminary trials are recommended
Test the adhesion to plastics, powder coatings, exotic woods and bituminous materials
Start by strengthening weak and > or porous substrates with Fixprimer
Due to the diversity of varnishes and paints on the market we recommend preliminary tests. Using products based on alkyd resins may delay the drying process
Use Tec7 cleaner to clean and degrease safely, obtain the perfect finish, and to remove uncured Tec7 polymers. Use HP Clean to finish porous materials
When glueing mirrors in sanitary facilities only apply vertical strips of adhesive to avoid stagnant moisture due to condensation
Minimal thickness of the adhesive: 2 mm. Ideal adhesive thickness for optimal adhesion strength: 3 mm
The spout features a V groove to allow you to dose out the right thickness of the adhesive. Do not cut it off
When applying, place the nozzle perpendicular to the surface
Use Tec gun for easiest application
To achieve the strongest adhesion with the fastest curing time apply adhesive in strips (as opposed to glue dots)
